Owner Resources

HVAC License Rules by City in Wyoming

We did not find an official State page saying in terms that no statewide HVAC license exists, so confirm with the State and your city. The State licenses limited electrical wiring for HVAC; Casper, Laramie and Cheyenne license mechanical work. This is general education, not legal or licensing advice; confirm current rules with your licensing board or building department.

What the State licenses on the wiring side, and what we could not confirm

I am Nate Jones, an insurance broker, and I read licensing pages because the insurance proof a city asks for is where my work meets yours. Our HVAC contractor insurance in Wyoming page gives the wider picture, and our guide on how to get an HVAC license covers the state and federal credentials side by side.

The Department of Fire Prevention and Electrical Safety runs the State electrical licensing program, and its electrical licensing page lists a limited electrical technician category for heating, ventilating and air conditioning work. The page restricts it to electrical work on the load side of the equipment disconnect. The identifier on that page is LM-H.

Statute points the same way. W.S. 35-9-123 lets the chief electrical inspector issue a limited electrical contractor license for installing, repairing or remodeling heating, ventilating and air conditioning systems, again limited to wiring on the load side of the equipment disconnect.

Both are electrical categories, and the wording we read covers wiring. Do not take them as a State license for setting equipment, running duct or working on a refrigerant circuit.

The honest answer to the title stops where our sources stop. We read the State electrical program pages, the adopted-codes page and the State’s fire prevention and electrical safety statutes. We found electrical categories and code adoption. We did not find a State mechanical or HVAC contractor license list, or a State page that states the negative outright. Absence from the pages we read is not a statement by the State, so ask the Department in writing, ask the city where the work sits, and keep the replies.

Where the mechanical code is enforced

The State has adopted the International Mechanical Code, along with the fire, building and fuel gas codes, as part of its statewide adopted codes. Adopting a model code names the rulebook. It does not say who licenses the people who work under it.

On enforcement, W.S. 35-9-121 directs the state fire marshal to delegate enforcement authority over local or state building standards to municipalities and counties that apply and qualify. So in delegated jurisdictions, building-code enforcement sits locally. That statute does not itself mention contractor licensing, which is why the city pages below matter.

For the permit side of a job, what insurance commercial HVAC clients require is a useful companion, because a city and a customer each set their own proof requirements.

Casper: the certificate waits for Building Official approval

Casper reviews general, sub and plumbing, mechanical and individual contractor license applications through its Community Development Department and the Chief Building Official. The city’s plumbing, mechanical and individual contractor page describes a Mechanical Contractor license that spans heating, ventilation and air conditioning, with refrigeration and the related sheet metal as well.

An applicant for that license must hold, or show proof of employing, a full-time licensed mechanical master. Casper also licenses individuals at master, journeyman and apprentice levels for HVAC and refrigeration work, and master and journeyman applicants must show proof of successful testing for their category.

Gas work is separate in Casper. Gas piping and gas appliance installation, except water heaters and boilers, fall under a Gas Utility Contractor classification that requires a full-time licensed gas utility installer or master plumber. If your crew does both mechanical and gas work in Casper, you are looking at separate classifications.

On insurance, the order is the point. Casper requires proof of insurance, a certificate, after the Building Official approves the application and before the license is issued. The city also asks that payment not be sent at the time of application. We could not retrieve Casper’s application forms, so we cannot tell you which coverage types the form lists; get the form and read it before you call your agent.

Laramie: the certificate arrives with the application

Laramie turns the order around. The city’s contractor licensing page requires trade contractors, including mechanical and refrigeration, to hold a valid City of Laramie contractor license. Its classifications include a Mechanical Contractor license and a Refrigeration Contractor license, and its Code Administration office handles trade contractor licenses alongside building permits and general contractor licenses.

Individuals matter too. People doing work in the licensed trades, including masters, journeymen and apprentices, must also be licensed by the city. A license holder must be represented at all times by a person holding a current City of Laramie master or supervisor certificate of qualification, so the license belongs to the business and the certificate belongs to the person.

Laramie requires the needed permits and licenses to be obtained before any work begins. For insurance, it requires a certificate of insurance naming the City of Laramie as certificate holder, provided with the license application. It also requires proof of workers’ compensation coverage, in the form of a State of Wyoming Workers Compensation Certificate of Good Standing, with the application.

Real-World Scenario: An illustration, not a real account. A Casper shop wins a service contract in Laramie and assumes the paperwork rhythm it knows will carry over. It waits for approval before asking its agent for a certificate. Laramie wanted the certificate and the good-standing proof in the application package, so the application sits incomplete while the customer waits. The shop that reads each city’s page before applying avoids that delay.

Cheyenne: proof after approval, and suspension if cover lapses

Cheyenne’s contractor licensing regulations require contractor and building trade licenses for work on buildings or structures within the city. The Contractor Licensing Board regulates certain building trades by requiring that only licensed contractors, and persons actively supervised by licensed contractors, may engage in them.

The regulations define an HVAC contractor class, Class C1, covering warm air heating systems, duct work, venting systems and general sheet metal work. Refrigeration is a separate listed license, and refrigeration applicants must submit current refrigerant certification of Type II, Type III or Universal. A contractor license holder must employ a person who holds a master or qualified supervisor license in the trade. For some trades, including HVAC and refrigeration, all employees on a job site must hold a master, journeyman or apprentice license or be a qualified supervisor.

The electrical side shows up again here. Cheyenne’s HVAC license requires a separate limited electrical license, described as an HVAC type, to do electrical work on the load side of the disconnect. That mirrors the State category above, and it is a city license type, so confirm it with Cheyenne.

On timing, Cheyenne is the Casper pattern with a harder edge. The certificate of insurance and the Wyoming workers’ compensation letter of good standing need not be submitted until the application has been approved, but Cheyenne issues no license until both have been provided. The city must be named as certificate holder. It requires commercial general liability insurance with minimums that vary by license class, and Wyoming workers’ compensation insurance when required by applicable Wyoming law and regulation.

The harder edge is suspension. The Building Official may suspend a license when the licensee’s insurance policy is cancelled or evidence of coverage, including workers’ compensation, is not provided. A lapse after you are licensed can reach the license itself. Ask your agent to tell you before any cancellation notice would reach the city, and see our page on general liability for what that policy is for.

Casper
Application
↓
Building Official approval
↓
Insurance proof, then license
Laramie
Application with insurance proof and good-standing proof attached
Cheyenne
Application
↓
Official approval
↓
Insurance proof, then license; suspension if cover is cancelled
State: electrical wiring license for HVAC; codes enforced locally
When each city asks for insurance proof, set against the State’s narrow electrical role. Order differs by city. No figures are shown.

Registering for workers compensation before the crew starts

Now the State side that does reach each employer. The workers’ compensation division sits within the Department of Workforce Services (W.S. 27-14-102(a)(vi)). Under W.S. 27-14-207(a), an employer subject to the Act may not commence business or engage in work in Wyoming without applying for coverage and receiving a statement of coverage from the division.

The Department says on its employer page that coverage through DWS is required before work begins in Wyoming for businesses in extra-hazardous industries, and that DWS classifies by NAICS. Out-of-state as well as Wyoming-based employers must complete the joint registration, which matters if your shop sits across a state line and bids here.

The statute deems the construction sector extrahazardous employment, regardless of individual occupation (W.S. 27-14-108(a)(ii)(D)). The statute does not itself place HVAC contractors in a sector. DWS assigns a classification to each business after it reviews the registration, so the classification is set by DWS, not chosen by you. Ask DWS how it classifies your business, and keep the answer. Our post on reducing HVAC workers comp costs explains why that classification drives so much of the bill, and our workers compensation page shows how the coverage fits a program.

The cities above ask for the proof this registration produces, which is why registering late can stall a city license.

Owners, officers and independent contractors

Do not assume the owner is covered. DWS states that owners are not automatically covered, and that a written request on a division affidavit is needed to add coverage.

The statute is specific. A sole proprietor or partner is not an employee under the Act unless coverage is elected under the owner-and-officer election subsection (W.S. 27-14-102(a)(vii)(B)). The same is true of a corporate officer (W.S. 27-14-102(a)(vii)(C)) and of a member of a limited liability company (W.S. 27-14-102(a)(vii)(P)). A corporation, LLC, partnership or sole proprietorship may elect coverage for its officers, members, partners or sole proprietor by notifying the division in writing (W.S. 27-14-108(k)). An employer that elects owner or officer coverage and has other employees must simultaneously elect coverage for those employees if they are not already covered.

An individual engaged as an independent contractor is not an employee under the Act (W.S. 27-14-102(a)(vii)(D)). The Act defines the term in W.S. 27-14-102(a)(xxiii), and the definition has several parts. It requires freedom from control or direction over the details of the services, by contract and by fact, but that is an element, not the whole test. Do not decide that a helper is an independent contractor because they bring their own truck.

Exclusive remedy, a lapse, and subcontractor premiums

For employers who qualify and pay, the Act’s remedies are in lieu of all other rights and remedies against the employer (W.S. 27-14-104(a)). That is the exclusive-remedy protection. The statute carries exceptions, intentional acts among them, so do not treat it as absolute.

The protection depends on standing. The Act does not limit an employee’s or dependents’ action against an employer that failed to qualify, or qualified and then left the required premium unpaid (W.S. 27-14-104(c)). For a shop owner, that is the practical reason to treat registration and premium payment as a duty of the business, not an office chore.

If you sub out part of a job, W.S. 27-14-206(e) matters. On private work, a contractor who subcontracts any part of a contract is liable for workers’ compensation premiums of the subcontractor’s employees unless the subcontractor primarily liable has paid them.

So collect proof of coverage from your subs before they set foot on the job, and ask the division how the rule applies to your arrangement. The paper side of that request is laid out in our guide to general contractor insurance demands on subs goes through it.

A short list to settle before you bid in a Wyoming city

None of this is a substitute for the city’s own page, but a short list keeps the paperwork in order:

  • Ask the Department of Fire Prevention and Electrical Safety whether your wiring scope needs the limited electrical category, and keep the written reply.
  • Ask the building department in the city of the job which mechanical or refrigeration license it requires, and when it wants the certificate.
  • Ask DWS how it classifies your business, and register before work starts.
  • Decide on purpose whether owners and officers will elect coverage, and put the election in writing to the division.
  • Collect coverage proof from each subcontractor.
  • Keep federal refrigerant certification separate. EPA says its Clean Air Act refrigerant regulations require certification for technicians who service or dispose of equipment that could release ozone-depleting refrigerants, and that EPA does not issue certification cards. The EPA Section 608 page has the details, and our post on EPA 608 certification and HVAC insurance shows where it touches coverage.

The HVAC contractor insurance hub shows how these pieces sit in a program, and our list of states we serve covers other states. When your city paperwork is ready, request a quote.

The bottom line

We did not find an official State page that says in terms there is no statewide HVAC contractor license, so do not rely on us or anyone else for that negative; ask the Department and the city where the job sits. What we can show from official sources is the State’s limited electrical license for HVAC wiring, local enforcement of the building codes, and city licensing in Casper, Laramie and Cheyenne, each with its own timing for insurance proof.

Frequently asked questions

Does Wyoming have a statewide HVAC license?

We did not find an official State page that says in terms there is no statewide HVAC contractor license, so we will not assert it. What we found is a State electrical license category for HVAC wiring on the load side of the disconnect, plus city licenses for mechanical work in Casper, Laramie and Cheyenne. Confirm with the Department of Fire Prevention and Electrical Safety and with your city.

Does the State license any part of HVAC work?

Yes, the electrical part. The State electrical licensing program lists a limited electrical technician category for heating, ventilating and air conditioning, and statute lets the chief electrical inspector issue a limited electrical contractor license for HVAC systems. Both are limited to wiring on the load side of the equipment disconnect, so they cover the electrical portion of the job, not the mechanical work.

When does a city want my certificate of insurance?

It depends on the city. Casper asks for proof of insurance after the Building Official approves the application and before the license is issued. Laramie wants a certificate naming the city as holder with the application itself. Cheyenne does not need the certificate until the application is approved, and it issues no license until the certificate is provided. Ask the city that issues the permit.

Do I need workers compensation registration before I start a job in Wyoming?

Wyoming statute says an employer subject to the Act may not commence business or engage in work in the state without applying for coverage and receiving a statement of coverage from the division. The Department of Workforce Services says coverage through it is required before work begins for businesses in extra-hazardous industries, and out-of-state employers must register too. Confirm your classification with DWS.

Are owners and independent contractors covered by Wyoming workers compensation?

Not automatically. A sole proprietor, partner, corporate officer or LLC member is not an employee under the Act unless coverage is elected by notifying the division in writing, and an individual engaged as an independent contractor is not an employee either. The independent contractor definition has several parts, so freedom from control is only an element. Ask the division before you rely on that status.

What happens if I hire a subcontractor on private work?

Under W.S. 27-14-206(e), on private work a contractor who subcontracts any part of a contract is liable for workers compensation premiums of the subcontractor’s employees unless the subcontractor primarily liable has paid them. So collect proof from your subcontractors before they start, and ask the division how it applies to your arrangement. Your own coverage and theirs are separate questions.

About the author

Nate Jones, CPCU

Nate Jones, CPCU, is the founder of Wexford Insurance and HVAC Guard Insurance, a specialty insurance agency placing HVAC contractor coverage in 48 states across a 25-carrier specialty panel. He reads city licensing paperwork the way an underwriter does, checking that the certificate a city asks for, the workers compensation proof it wants, and the policy actually in force line up before the application goes in. Connect via the HVAC Guard Insurance quote form or call 317-942-0549.

Insure your HVAC business with a CPCU-led agency

Tell us how your operation runs — residential service, commercial and mechanical, or both — and we will market it to carriers that write the class.